braaap Wholesale—braaap ST-250 Motorcycle
What are the defects?
It is a mandatory requirement that a motorcycle must have each mechanical component accurately stamped and displayed for identification purposes according to regulation for ADR compliance.
The following parts have been incorrectly stamped for identification purposes;
• Fuel Tap
• Rear Master Cylinder Cap
• Tail light assembly
• The ADR83 stationary noise test information sticker is not displayed
What are the hazards?
The consumer is unable to verify the authenticity and manufacturing standards of these components and there is the possibility this could lead to the incorrect
replacement of parts which may affect vehicle performance and compromise the safety of the rider.
What should consumers do?
Customers should immediately contact and visit their place of purchase to have these components replaced at no expense.
Authorised dealers
- 29 June 2015 - 29 June 2016
Recall advertisements and supporting documentation
Responsible regulator
Department of Infrastructure, Transport, Regional Development and Communications is the responsible regulator for this recall.
