Mitsubishi Motors Australia Limited—various Mitsubishi models: PB & PC Challenger; GA & GB i-MiEV; CJ Lancer Sedan & Sportback; ZG & ZH Outlander; NS, NT, NW & NX Pajero; ML & MN Triton

Identifying features

See attached list for affected VIN ranges
Campaign numbers:
010106 PB, PC Challenger (target 11 846)
010107 GA, GB i-MiEV (target 237)
010108 CJ Lancer Sedan (target 92 954)
010109 CJ Lancer Sportback (target 28 269)
010110 ZG, ZH Outlander (target 46 262)
010111 NS, NT, NW, NX Pajero (target 50 733)
010112 ML, MN Triton 4x2 (target 43 616)
010113 ML, MN Triton 4x4 Auto (target 35 786)
010114 ML, MN Triton 4x4 Manual (target 73 676)

What are the defects?

The turn signal and lighting switch connector terminals may become worn during switch operation due to insufficient rigidity. This may result in an accumulation of oxidised dust on the connector terminals. Excessive dust accumulation can act as an insulator, affecting proper terminal conductivity.

What are the hazards?

Continued usage under this condition could cause conduction failure resulting in head lamp, turn signal lamps, parking lamp, front/rear fog lamp, tail lamp, number plate lamp and cabin lamp failing to operate or to operate intermittently.

What should consumers do?

Mitsubishi Motors Australia will contact all known owners by mail as soon as possible and advise them to present their vehicle to a Mitsubishi dealer for rectification.
Consumers who require further information should contact Mitsubishi Motors Australia on 1300 131211.

Traders who sold this product

Mitsubishi Motors Australia and authorised dealers

Where the product was sold

Recall advertisements and supporting documentation

Responsible regulator

Department of Infrastructure, Transport, Regional Development and Communications is the responsible regulator for this recall.

Department of Infrastructure, Transport, Regional Development and Communications
Product category