Pacific Impexp Services—Bunk Bed Model AB107-5656

Identifying features

N/A

What are the defects?

(a) one side of the bed has a raised edge side only – a guardrail is necessary to prevent the likelihood of a child rolling out of the bed or slipping down between the bed and a wall and being trapped by his/her head; (b) the width of the stair access is too wide by 600 mm (it must have a minimum width of 300 mm and a maximum of 400 mm) – the purpose of the prescribed width is to prevent a child from rolling or falling out of the bed;(c) there is a gap formed between the guardrail and the head end of the bed that is too wide by 150 mm (it must have a minimum width of 230 mm but not more than 400 mm) - the purpose of the prescribed gap is to prevent a child from rolling or falling out of the bed; (d) the gap between the guardrails is too substantial as it allows the passage of a 95 mm diameter probe – the purpose of a prescribed gap width of less 95 mm is to prevent a child from slipping between the gaps and potentially trapping or strangling himself/herself; and (e) the maximum mattress height and importer’s name and address were not marked on the bunk beds.

What are the hazards?

Injury

What should consumers do?

Please discontinue use of the bunk bed. Contact Pacific ImpExp Services on 02 4704 9426 to arrange modification of the bunk bed or a full refund of the purchase price.

Supplier
Pacific Impexp Services
Where the product was sold
Nationally

Responsible regulator

Australian Competition and Consumer Commission is the responsible regulator for this recall.

Australian Competition and Consumer Commission
Product category