PRA number
2016/15479
Published date
Product description
Onroad use motorcycle (ST250WO0022016)
Reasons the product is recalled
It is a mandatory requirement that a motorcycle must have each mechanical component accurately stamped and displayed for identification purposes according to regulation for ADR compliance.
The following parts have been incorrectly stamped for identification purposes;
• Fuel Tap
• Rear Master Cylinder Cap
• Tail light assembly
• The ADR83 stationary noise test information sticker is not displayed
The following parts have been incorrectly stamped for identification purposes;
• Fuel Tap
• Rear Master Cylinder Cap
• Tail light assembly
• The ADR83 stationary noise test information sticker is not displayed
The hazards to consumers
The consumer is unable to verify the authenticity and manufacturing standards of these components and there is the possibility this could lead to the incorrect
replacement of parts which may affect vehicle performance and compromise the safety of the rider.
replacement of parts which may affect vehicle performance and compromise the safety of the rider.
What consumers should do
Customers should immediately contact and visit their place of purchase to have these components replaced at no expense.
Supplier
Traders who sold this product
Authorised dealers
Where the product was sold
Nationally
Dates available for sale
-
Recall advertisements and supporting documentation
Responsible regulator
Department of Infrastructure, Transport, Regional Development and Communications is the responsible regulator for this recall.
